€ 27.99 · 4.5 (726) · In Magazzino
My son was using his Elegoo kit I got him. He had done lesson 3 (hardwire an LED), and was doing lesson 4 and could not get it to work. I then plugged in my Arduino Uno R3 to see if it was the Arduino. Same result. So I got out my volt meter, and I'm only getting a few millivolts between the V5 pin and GND. It's possible something was wrong with his circuit that fried the regulator on his board, and then when I plugged mine it it fried mine also? Anyway, I should always get +5 out of the
Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF
Arduino Uno 5 axis wiring - Hardware - Arduino Forum
Arduino uno +5V/GND pins question - IDE 1.x - Arduino Forum
Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF
main@
Getting more than 5v from the UNO 5v pin - Motors, Mechanics, Power and CNC - Arduino Forum
Stepper motors not responding - Motors, Mechanics, Power and CNC - Arduino Forum
Motor doesn't rotate without computer connection - Motors, Mechanics, Power and CNC - Arduino Forum
Connecting both DC motor and Servo Motor to Arduino When There is Only One 5V Pin in Arduino Uno - Robotics - Arduino Forum
Actuating A 5V Push/Pull Solenoid - Motors, Mechanics, Power and CNC - Arduino Forum