€ 29.50 · 4.7 (660) · In Magazzino
Hi all, I've been trying to connect an ENC28J60 ánd an SD cardreader module to an Arduino Nano on the SPI bus. Both modules work fine but only when the other module is not connected. Then I found this: SOLVED. Nrf24 (Mirf lib) + Micro SD-card works OK together I'm pretty sure I have the same problem. The SD card module is probably not playing nice on the SPI bus. The thread is marked as "SOLVED" but not really. What I've tried: -- desoldering an SMD pin en bridging it, that ended in one
i2c Arduino SAMD MKR: additional interface SERCOM, network and address scanner – Renzo Mischianti
Arduino Nano Motor Carrier - motor driver for Arduino Nano 33 IoT - ABX00041 Botland - Robotic Shop
Using TWO Enc28J60 on Arduino Nano V3 - Networking, Protocols, and Devices - Arduino Forum
enc28j60 no miso signal - Project Guidance - Arduino Forum
Simple data transfer network with ENC28J60/Arduino (Uno) - Networking, Protocols, and Devices - Arduino Forum
Nano Screw Terminal Adapter - screw connectors - hat for Arduino Nano - Arduino ASX00037 Botland - Robotic Shop
Arduino UNO + Ethernet module (ENC28J60) - Wchih library to control the LEDs - IDE 1.x - Arduino Forum
Ethernet 10/100 Mb/s - UART Converter for Raspberry Pi Pico - Waveshare 20410 Botland - Robotic Shop
Multiple SPI Ethernet and SD card reader (not shield) - Networking, Protocols, and Devices - Arduino Forum
How to get the best out of this forum - IDE 1.x - Arduino Forum
RFID music launcher - Exhibition / Gallery - Arduino Forum
Problems with ENC28j60 and MFRC522 - Networking, Protocols, and Devices - Arduino Forum