EPever 3210AN 12V/24V MPPT Battery Regulator Charge Controller with Ma – Temank

EPever 1210AN 12V/24V MPPT Battery Regulator Charger Controller with Max PV Input 100v for Solar home System Solar Charge Controller Brand: Temank Apllication: Solar home System, field monitoring, stations, etc Advanced MPPT technology
Solar Charge Controller Brand: Temank Apllication: Solar home System, field monitoring system, stations System, etc Advanced MPPT technology, with efficiency no less than 99.5% Ultra-fast tracking speed and guaranteed tracking efficiency Advanced MPPT control algorithm to minimize the maximum power point loss rate and loss time Wide MPP operating voltage range High quality components, perfecting system performance, with maximum conversion efficiency of 98% Accurate recognition and tracking of multiple-peaks maximum power point International famous brands of ST and IR's components of high quality and low failure rate are used, which can ensure the product’s service life Charging power and current limitation function Compatible with lead-acid and lithium-ion batteries Battery temperature compensation function Real-time energy statistics function Overheating power reduction function Multiple load work modes The communication port adopts professional protection chip, which can provide 5VDC power supply, and has over-current and short-circuit protection. With RS-485 communication bus interface and Modbus communication protocol, it is available to meet various communication requirements in different situations. Monitor and set the parameters via mobile phone APP or PC software Full-load operation without any drop in capacity within the range of working environment temperature Extensive electronic protection   ★If the temperature sensor is short-circuited or damaged, the controller will charge or discharge at the default temperature setting of 25 ºC.   Maximum Power Point Tracking Technology Due to the nonlinear characteristics of solar array, there is a maximum energy output point (Max Power Point) on its curve. Traditional controllers, with switch charging technology and PWM charging technology, can’t charge the battery at the maximum power point, so can’t harvest the maximum energy available from PV array, but the solar charge controller with Maximum Power Point Tracking (MPPT) Technology can lock on the point to harvest the maximum energy and deliver it to the battery. The MPPT algorithm of our company continuously compares and adjusts the operating points to attempt to locate the maximum power point of the array. The tracking process is fully automatic and does not need user adjustment. As the Figure 1-2, the curve is also the characteristic curve of the array, the MPPT technology will ‘boost’ the battery charge current through tracking the MPP. Assuming 100% conversion efficiency of the solar system, in that way, the following formula is established: Figure 1-2 is the maximum power point curve, the shaded area is charging range of traditional solar charge controller (PWM Charging Mode), it can obviously diagnose 3that the MPPT mode can improve the usage of the solar energy resource. According to our test, the MPPT controller can raise 20%-30% efficiency compared to the PWM controller. (Value may be fluctuant due to the influence of the ambient circumstance and energy loss.) In actual application, as shading from cloud, tree and snow, the panel maybe appear Multi-MPP, but in actually there is only one real Maximum Power Point. As the below Figure 1-3 shows:   If the program works improperly after appearing Multi-MPP, the system will not work on the real max power point, which may waste most solar energy resources and seriously affect the normal operation of the system. The typical MPPT algorithm, designed by our company, can track the real MPP quickly and accurately, improve the utilization rate of the array and avoid the waste of resources. Battery Charging Stage The controller has a 3 stages battery charging algorithm (Bulk Charging, Constant Charging and Float Charging) for rapid, efficient, and safe battery charging. A) Bulk Charging In this stage, the battery voltage has not yet reached constant voltage (Equalize or Boost Voltage), the controller operates in constant current mode, delivering its maximum current to the batteries (MPPT Charging). B) Constant Charging When the battery voltage reaches the constant voltage setpoint, the controller will start to operate in constant charging mode, this process is no longer MPPT charging, and in the meantime the charging current will drop gradually, the process is not the MPPT charging. The Constant Charging has 2 stages, equalize and boost. These two stages are not carried out constantly in a full charge process to avoid too much gas precipitation or overheating of battery. There is detail information about 3210AN 12V/24V MPPT Battery Regulator Charger Controller

Temank EPEVER Dual Battery Solar Charge Controller 20A 12V 24V Duo-Battery Solar Controller for RVs Caravans and Boats-New Version : Patio, Lawn & Garden

EPEVER Tracer MPPT 40A 30A 20A 10A Solar Charger Controller LCD 12V24V Auto High Efficiency Regulador Solar 4210AN 3210AN 2210AN

EPever 3210AN 12V/24V MPPT Battery Regulator Charge Controller with Ma – Temank

EPEVER Tracer MPPT 40A 30A 20A 10A Solar Charger Controller LCD 12V24V Auto High Efficiency Regulador Solar 4210AN 3210AN 2210AN

EPEVER 10A MPPT Solar Charge Controller 12/24V DC Tracer-an Series Charge Controller with MT50 Remote Meter &Temperature Sensor &RS485 fit for Lithium, Sealed, AGM Battery Charging Negative Grounded : Patio, Lawn & Garden

EPEVER MPPT Charge Controller 40A 12V / 24V Auto, Solar Charge Controller 150V PV Negative Grounded Solar Regulator for Gel Sealed Flooded Battery（Tracer 4215BN） : Patio, Lawn & Garden

EPEVER MPPT Charge Controller 30A 12V 24V Auto Max PV 100V Solar Panel Generator Common Negative Ground Regulator Tracer3210AN with LCD Display for Gel AGM Flooded Sealed Lithium Battery (30A

☀Updated Version EPEVER Tracer-AN series : MPPT Solar Charge 40A 12V/24V Auto, Max PV 100V and Max input solar panels power: 520W for 12V battery

EPEVER 40A MPPT Solar Charge Controller, 12V/24V Auto, Max Input 100V Solar Panel 520W/1040W Regulator for Gel Sealed Flooded AGM Lithium Battery

EPEVER MPPT Charge Controller 30A Tracer3210AN + Remote Meter MT50 + RTS Temp Sensor 12V/24V Auto for Solar Panel Charging Battery Regulator System

, Overview, The TRIRON series controllers are modular-designed products based on nine MPPT solar controller models. The main unit (Power Module)

Temank EPever 40A MPPT Solar Charge Controller 12V/24V Auto 2USB For Lithium Battery and Lead Acid Battery

Temank EPever MPPT Dual Battery Solar Controller Regulator DR3210N 30A