No 5V+ from Arduino Uno R3 - Motors, Mechanics, Power and CNC

My son was using his Elegoo kit I got him. He had done lesson 3 (hardwire an LED), and was doing lesson 4 and could not get it to work. I then plugged in my Arduino Uno R3 to see if it was the Arduino. Same result. So I got out my volt meter, and I'm only getting a few millivolts between the V5 pin and GND. It's possible something was wrong with his circuit that fried the regulator on his board, and then when I plugged mine it it fried mine also? Anyway, I should always get +5 out of the

The K3NG Arduino CW Keyer – Radio Artisan

Stepper motor + Arduino Uno + CNC Shield + DRV8825 and it doesn't work - Motors, Mechanics, Power and CNC - Arduino Forum

How to power Motor and Arduino with single power source - Motors, Mechanics, Power and CNC - Arduino Forum

No 5V+ from Arduino Uno R3 - Motors, Mechanics, Power and CNC - Arduino Forum

Arduino Uno and Electrical Basics - Troubleshooting - V1 Engineering Forum

SOLVED] Bi-directional motor control with two mosfets? - General Electronics - Arduino Forum

Sometimes Stepper motor can not move - Motors, Mechanics, Power and CNC - Arduino Forum

Stepper motors not responding - Motors, Mechanics, Power and CNC - Arduino Forum

GRBL UNO R3 Controller Bundle with Nema23 1.26N.m Stepper Motors

Controlling dc motor with power supply instead of arduino. - Motors, Mechanics, Power and CNC - Arduino Forum

Elecrow Arduino CNC Shield V3.51 - GRBL v0.9 Compatible: : Industrial & Scientific