Trouble with 12V Relay attached to Pump - Arduino MEGA2560

I have attached to my Arduino a 2 Channel 12V Relay. Currently the red light on the Relay is working as my program switches LOW and HIGH every 5 seconds, so I know it's communicating. My 12VDC/AC power supply is plugged in the + is spliced in through the orange wire connected to the COM2. On the NO2 I have the +(pos) going to the pump. The -(neg) of the pump is connected to the power supplies -(neg). For some reason I get no response from the NO2 switching on or off. When the red light on the

1 Channel 12V Relay Module with Optocoupler Support High and Low Trigg

Trouble with 12V Relay attached to Pump - Arduino MEGA2560 - Project Guidance - Arduino Forum

DIY: Relay Switch Motor Controller - Arduino : 4 Steps (with Pictures) - Instructables

12v Relay issue - Hardware - Arduino Forum

Can't turn on 12v relay with output pins - General Electronics - Arduino Forum

Solenoid valve with Arduino, Arduino interface with Solenoid Valve

Arduino Mega 2560 and 8 Channel relay module - General Electronics - Arduino Forum

Blynking an IoT Yunshan ESP8266 250V 10A AC/DC WIFI Network Relay Module

Arduino Mega 2560 and 8 Channel relay module - General Electronics - Arduino Forum

Arduino - 4-Channel Relay Module

Trying to connect 12V DC irrigation pump using Relay and power supply - Motors, Mechanics, Power and CNC - Arduino Forum

Trouble with 12V Relay attached to Pump - Arduino MEGA2560 - Project Guidance - Arduino Forum

How to Set Up a 5V Relay on the Arduino - Circuit Basics

Guide for Relay Module with Arduino

Arduino Mega 2560 and 8 Channel relay module - General Electronics - Arduino Forum