€ 22.99 · 4.5 (717) · In Magazzino
Hello. The relay module controls the 220V fluorescent lamp in Arduino. It has been confirmed that the lamp also operates whenever the relay module is switched on and off. But I want to put in a fuse holder because I want to control it while preventing overcurrent more safely, Is it okay to connect the circuit like this?? I'm currently using an Arduino unit3 compatible board. Below is the code used. void setup() { // put your setup code here, to run once: pinMode(9, OUTPUT); } void
Relay control of 220v 150w fan - General Electronics - Arduino Forum
Relay Module stops working mid cycle - General Electronics - Arduino Forum
Overriding 220V switch with arduino - General Electronics - Arduino Forum
Relay module effecting Arduino - General Electronics - Arduino Forum
Operating a 27 V DC solenoid using Arduino UNO and relay - Robotics - Arduino Forum
Relay Interface With Arduino
Safety concerns about generic Arduino relay modules - Project Guidance - Arduino Forum
5v Relay - Switching Between 240v Supplies - General Electronics - Arduino Forum
Relay for arduino - Motors, Mechanics, Power and CNC - Arduino Forum
Guide for Relay Module with Arduino